Table Solution?

[AlexinCalgary]

Our table in our bunkhouse uses this setup and is really solid, no wobble at all. We like the fact that there is leg space underneath too since the one leg is only off to the side not under the table. I purchased the Kit from Amazon to install only to find out the swing piece is too wide, our main living area table is smaller than the bunkhouse one.

My question for the folks here is the wall mount brackets themselves, how do I screw these to the wall without them just falling out? The brackets will likely be only less than an inch below the window but are there some type of studs to screw into?

 

[KtownKajun]

We have had pretty good luck with these, I don’t know how thick your walls are so.make sure they won’t puncture the outer skin.

https://www.lowes.com/pd/e-z-ancor-6-pa ... gKnTPD_BwE

 

[Jimc3165]

You also can mount a piece of aluminum across to spread out the stress and then mount to your aluminum. you might be able to locate the studs with a stud finder.

 

[ChappyKC]

Ours had double legs and it wobbled. I took the legs off and attached a folding X stand like you use for a portable keyboard to play on. I used PVC pipe clamps. Now I can leave it down or I can leave it up. And I can move it around and take it outside. Much better in my opinion.