2012 RT320RES need help on converter wiring ASAP

mobilefleet

New Member
Joined
Jan 29, 2024
Posts
3
Hello all, I bought a 2012 open range RT320RES from an insurance auction and it was missing the converter and all the wires were cut. I'm trying to figure out what model converter came in this unit, it has 3 slides and is 50 amp service. I contacted OR which is now owned by Jayco and they say they don't have a wiring diagram. Hoping someone on here can help!
 
Virtually any converter will work.

Assuming it is free standing and not installed in the fuse panel.

I would purchase a 50-60 AMP or so converter. Must be lithium capable. You need lithium batteries. Note the battery wire sizes. Larger may be better. Bluetooth monitors on the batteries will tell you if the wires are too small.

Most require a screw to hold it to the floor. Then they have a 120 volt ac plug that plugs in somewhere. Three wires run to it. A ground to a lug on the device and two connected to the battery. Use a voltmeter to get them right.

Usually a ten minute project. Of course sometimes access is awful and the fun begins.
 
Progressive Dynamics is the company I have done business with. Their phone number is 1-800-940-8924. When I was switching to lithium Batteries I talked to them several times and they always answered all my questions and were very helpful.Dave
 

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top Bottom